Another Lego Crane

Over the last week, I assembled this Lego kit:

IMG_1256

IMG_1262

As far as these kits go, this one is seriously lacking originality, being almost identical in design and construction to other cranes I have made before.

As it turns out my familiarity with the basic design would almost be my downfall! This kit has 108 pages of assembly instructions, with over 250 individual steps. And on the 19th page, less than 20% into the construction, I made an error. This isn’t the end of the world – everyone makes mistakes with complex Lego kits here and there. But this tiny mistake became massive indeed since I didn’t notice it until over 70 pages later!

Here it is:

IMG_1291

See that circled piece? We’ll call than an ‘eleven-er’. It should have been 2 tabs shorter, a ‘nine-er’. But it’s so embedded into the construction of the crane that removal at this point would require essentially dismantling 50% of the build and redoing it – losing many hours of work. What was I to do? I was so close to the finish at this point that my options were few, and I really, really didn’t want to dismantle and start again. So I had a brainwave:

IMG_1293

Can’t see the fix can you? The curved piece on the side of the crane is attached using the 9 piece that I should have used 70 pages earlier. I had to attach it differently (the original instructions required the 11 piece and it was attached at the bottom not at the top as I did). But it’s very clean and it’s only visible in profile that there is an error:

IMG_1294

Notice how on the left side the side panel is not flush with the body of the crane? Not perfect perhaps, but good enough πŸ™‚

Here’s the final product compared to a very large animal so you can see how big it is:

IMG_1295

It’s a very nice kit. The crane can be raised and lowered, and the claw at the end opens and closes using a fascinating mechanism. The kit can also be fitted with the technic motor and be battery driven, but my motor is still in my other crane so I didn’t do that. All things considered this is a great kit and while derivative of the other cranes I’m glad I own it πŸ™‚

2 Responses to “Another Lego Crane”

  1. mycroft says:

    You left out the final step: pick up cat with crane and place inside ring πŸ˜‰

  2. Robert says:

    I doubt there’s a crane on Earth that could lift that cat πŸ˜‰